 |
x2745 DPP-PSD 2025052200
CUP documentation
|
|
x2745 DPP-PSD 2025052200
CUP documentation
|
Resets the board. This command sets all registers to the default value and clears data from memories. It does not act on the communication interfaces, the PLLs and the clocks.
Options:
Level: DIGSet in Run: False
Sets a timer that reboots the board after 4 seconds. The communication is lost and must be established again after the reboot. The default firmware is loded.
Options:
Level: DIGSet in Run: True
Clears data from memories. Register's content is not affected. This command is typically used before starting an acquisition to guarantee that no data belonging to a previous run is still present in the internal memory of the digitizer.
Options:
Level: DIGSet in Run: False
Arms the digitizer to start an acquisition. When the start of run is software controlled, the arming is implicit in the start command, and it is not necessary to use the ArmAcquisition command.
Options:
Level: DIGSet in Run: False
Disarms the acquisition and prevents the digitizer to start a new run (for instance, controlled by an external signal feeding SIN) without the grant of the software. It is possible to set an automatic disarm after the stop of the acquisition by means of the EnAutoDisarmAcq parameter.
Options:
Level: DIGSet in Run: True
Starts the acquisition, provided that the option Swcmd is enabled in the parameter. This command does not require a previous arming command.
Options:
Level: DIGSet in Run: True
Forces the acquisition to stop, whatever is the start source.
Options:
Level: DIGSet in Run: True
Sends a software trigger to the digitizer, provided that the SwTrg option is enabled.
Options:
Level: DIGSet in Run: True
Send a software trigger to the selected channels, provided that the option SwTrg is enabled in the GlobalTriggerSource parameter.
Options:
Level: CHSet in Run: True
Deletes calibration file and reload it from flash or, if invalid, use default calibration.
Options:
Level: DIGSet in Run: True
1.9.2