Reset

Resets the board. This command sets all registers to the default value and clears data from memories. It does not act on the communication interfaces, the PLLs and the clocks.

Options:

• Level: DIG
• Set in Run: False

Reboot

Sets a timer that reboots the board after 4 seconds. The communication is lost and must be established again after the reboot. The default firmware is loded.

Options:

• Level: DIG
• Set in Run: True

ClearData

Clears data from memories. Register's content is not affected. This command is typically used before starting an acquisition to guarantee that no data belonging to a previous run is still present in the internal memory of the digitizer.

Options:

• Level: DIG
• Set in Run: False

ArmAcquisition

Arms the digitizer to start an acquisition. When the start of run is software controlled, the arming is implicit in the start command, and it is not necessary to use the ArmAcquisition command.

Options:

• Level: DIG
• Set in Run: False

DisarmAcquisition

Disarms the acquisition and prevents the digitizer to start a new run (for instance, controlled by an external signal feeding SIN) without the grant of the software. It is possible to set an automatic disarm after the stop of the acquisition by means of the EnAutoDisarmAcq parameter.

Options:

• Level: DIG
• Set in Run: True

SwStartAcquisition

Starts the acquisition, provided that the option Swcmd is enabled in the parameter. This command does not require a previous arming command.

Options:

• Level: DIG
• Set in Run: True

SwStopAcquisition

Forces the acquisition to stop, whatever is the start source.

Options:

• Level: DIG
• Set in Run: True

SendSWTrigger

Sends a software trigger to the digitizer, provided that the SwTrg option is enabled.

Options:

• Level: DIG
• Set in Run: True

ReloadCalibration

Deletes calibration file and reload it from flash or, if invalid, use default calibration.

Options:

• Level: DIG
• Set in Run: True